OpenCorsairLink is a command-line tool to monitor and control the fan speed, LED colour and pump volumes of specific Corsair power supplies and cooling solutions.
To allow this snap access to your device(s), issue the following connection commands:
$ sudo snap connect opencorsairlink:raw-usb
$ sudo snap connect opencorsairlink:hardware-observe
Examples:
To set your own custom fan curve for a specific set of temperatures, use the following command:
$ sudo opencorsairlink --device 1 --fan channel=1,mode=6,temps=0:35:45:50:55:60,speeds=0:0:55:60:75:100
To set LED colors and mode:
$ sudo opencorsairlink --device 0 --led channel=0,mode=0,colors=00FF00
To set pump cooling mode:
$ sudo opencorsairlink --device 0 --pump mode=5
OpenCorsairLink is unofficial and is not endorsed or affiliated with Corsair.
General options:
----fan: set fan mode and create speed profiles ---pump: set pump cooling mode
LED (--led) options: (after specifying a device):
channel=N,mode=N,colors=HHHHHH:HHHHHH:HHHHHH,temps=TEMP:TEMP:TEMP
Fan (--fan) options: (after specifying a device):
channel=N,mode=N,pwm=PWM,rpm=RPM,temps=TEMP:TEMP:TEMP,speeds=SPEED:SPEED:SPEED
-mode=:
Pump (--pump) options: (after specifying a device): -mode=:
Without options, OpenCorsairLink will show the status of any detected Corsair Link device.
Thank you for your report. Information you provided will help us investigate further.
There was an error while sending your report. Please try again later.
You are about to open
Do you wish to proceed?
Snaps are applications packaged with all their dependencies to run on all popular Linux distributions from a single build. They update automatically and roll back gracefully.
Snaps are discoverable and installable from the Snap Store, an app store with an audience of millions.
If you’re running Kubuntu 16.04 LTS (Xenial Xerus) or later, including Kubuntu 18.04 LTS (Bionic Beaver) and Kubuntu 18.10 (Cosmic Cuttlefish), you don’t need to do anything. Snap is already installed and ready to go.
Versions of Kubuntu between 14.04 LTS (Trusty Tahr) and 15.10 (Wily Werewolf) don’t include snap by default, but snap can be installed from the command line as follows:
sudo apt update
sudo apt install snapd
To install OpenCorsairLink, simply use the following command:
sudo snap install opencorsairlink
Browse and find snaps from the convenience of your desktop using the snap store snap.
Interested to find out more about snaps? Want to publish your own application? Visit snapcraft.io now.