small printer daemon intended for diskless workstations
A small printer daemon intended for diskless platforms that does not spool
to disk but passes the job directly to the printer. Normally a lpr daemon on
a spooling host connects to it with a TCP connection on port 910n
(where n=0, 1, or 2 for lp0, 1 and 2 respectively).
p910nd is particularly useful for diskless platforms.
Common Unix Printing System (CUPS) supports this protocol, it's called the
AppSocket protocol and has the scheme
Windows and Mac Os X (via CUPS) also supports this protocol.
You need to allow p910nd access to the usb printer by connecting the raw-usb
snap connect p910nd-ogra:raw-usb
... else the daemon will not start.
optionally you can configure the following settings though snap set commands:
snap set p910nd-ogra device="/dev/usb/lp0"
snap set p910nd-ogra bindaddr="192.168.1.5"
additionally enabling/disabling bidirectional communication can be done with:
snap set p910nd-ogra bidirectional=true
snap set p910nd-ogra bidirectional=''
Note: some printers tend to automatically suspend the USB bus, to prevent
/dev/usb/lp* from going away after a while, set usbcore.autosuspend=0 on your
Swap out openSUSE_Leap_15.5 for openSUSE_Leap_15.4 or openSUSE_Tumbleweed if you’re using a different version of openSUSE.
With the repository added, import its GPG key:
sudo zypper --gpg-auto-import-keys refresh
Finally, upgrade the package cache to include the new snappy repository:
sudo zypper dup --from snappy
Snap can now be installed with the following:
sudo zypper install snapd
You then need to either reboot, logout/login or source /etc/profile to have /snap/bin added to PATH.
Additionally, enable and start both the snapd and the snapd.apparmor services with the following commands: