Install latest/stable of Enapter UCM Kit Flasher
Ubuntu 16.04 or later?
Make sure snap support is enabled in your Desktop store.
Install using the command line
sudo snap install flasher-enapterDon't have snapd? Get set up for snaps.
Application for uploading latest Enapter IoT firmwares for Espressif ESP32 chip for wide range Enapter UCM Kits.
Enapter UCM Kit is based on several important open-source and free-to-use components. This provides possibilities for personal technology development and hardware prototyping all of which are extremely helpful for developing innovative, cost-efficient smart energy solutions for emerging markets.
UCM Kits can be assembled by hand with documentation at https://developers.enapter.com/docs/tutorial/ucm-kit/introduction
Setup
In order to upload firmware to development board over USB, you need to add your user to the dialout group. Open a terminal window, run the following command and reboot your computer.
> sudo usermod -a -G dialout $USER
> sudo snap connect flasher-enapter:raw-usb
Now restart your computer and you're good to go!
Are you having issues?
Contact with us in Discord: https://go.enapter.com/discord
Support our project
Put a ⭐ on Github: https://github.com/Enapter/marketplace
Thank you for your report. Information you provided will help us investigate further.
There was an error while sending your report. Please try again later.
You are about to open
Do you wish to proceed?
Generate an embeddable card to be shared on external websites.
Choose your Linux distribution to get detailed installation instructions. If yours is not shown, get more details on the installing snapd documentation.
