Iterating over a build
See Build options for an outline of alternative build environments.
To help speed up testing, it’s possible to open a shell within this environment to check the state of a build, view logs, probe the value of environment variables, locate missing binaries and install missing dependencies.
The following commands enable you to step into this encapsulated environment:
--shell: builds your snap to the lifecycle step prior to that specified and opens a shell into the environment (e.g. running
snapcraft prime --shellwill run up to the
stagestep and open a shell).
--shell-after: builds your snap to the lifecycle step specified and opens a shell into the environment. (eg. running
snapcraft prime --shell-afterwill run up to the
primestep and then drop into a shell).
--debug, opens a shell inside the environment after an error occurs.
For example, to open a shell just before the prime phase, use the following command:
$ snapcraft prime --shell Using 'snap/snapcraft.yaml': Project assets will be searched for from the 'snap' directory. Launching a VM. Launched: snapcraft-test [...] Pulling part-test Building part-test Staging part-test snapcraft-test #
If a build has already progressed past the stage specified, first clean the build or the part and re-build:
$ snapcraft clean $ snapcraft build --shell
Build and testing recommendations
Editing snapcraft.yaml, or the application itself, and rebuilding and re-installing each time can be time consuming, especially with larger snaps.
Here are a couple of approaches that can expedite the build process:
Edit snapcraft.yaml outside of the Snapcraft container shell environment and run
snapcraftwithin the shell to continue the build.
snapcraft --debug, rather than
snapcraft, to open a shell in the container environment as soon as a build error occurs.
Remaining within the container shell environment, with access to the various staging directories, makes it easier to troubleshoot problems such as wrongly located binaries, missing dependencies, and crashing processes.
tryargument with both the snapcraft and snap commands.
$ snapcraft trybuilds the snap and copies its prime directory to the current working directory on the host system - outside of any build environment container.
$ sudo snap try primeinstalls the snap by mounting the contents of the prime directory, rather than a snap file. This means when the contents of prime are edited, so too is the installed snap. Changes to interfaces in prime/meta/snap.yaml, however, require the snap to be removed and re-installed.
$ sudo snap remove <snapname>remove the snap by unmounting the prime directory.
These commands are useful when testing because files from the prime directory become easily viewable and modifiable without requiring a complete snapcraft rebuild. In-place fixes can then be migrated to the snap’s snapcraft.yaml for a final build.
Last updated 1 year, 23 days ago.